Pilot jet adjustment help!

[Gene]

'85 650cs Nighthawk.

I am enjoying my Nighthawk after rebuilding the carbs, however I need to adjust the pilot jets. Should be easy, however getting my big hands in there, especially when the bike is hot, is next to impossible.

A little while ago, I saw an adjustment tool it's long and uses a gear drive. Anyone know where to get one?

[Bob H]

It's made by Motion Pro, search Amazon or general Google search.
I got one very similar, not quite as compact, you can see it top of pg 9 here https://nighthawkforums.com/index.php?topic=39.120

The link for it was top of page 7, direct from China for $22 https://nighthawkforums.com/index.php?topic=39.90
I had to tighten a screw on the handle, it was kind of falling apart when it arrived, but tightened up OK.

For what it's worth, I don't think anything will fit in the tight space for the 750, maybe you will have better luck with the 650.

[Pete in PA]

Same.  Hope you have more room on the 650. I seem to remember being able to reach the idle adjustment screw with my hand when I had a 650 back in 84.

91 on, forget it.  I use a chopstick to adjust my idle, I bought this to try the pilot screws, Don't it's junk. Broke right away and too tall anyway to reach.

https://www.ebay.com/itm/275723665769?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=P_Qtk_YBRu-&sssrc=2349624&ssuid=IwajBBFPTpq&var=&widget_ver=artemis&media=COPY

[draser]

I have the MotionPro tool but it won't fit to adjust one of the carbs (carb 3 I believe). Works fine on my Magna though. I made me a short bit but it's still too big.

[Willie]

I thought I've revive this thread to ask if the Motion Pro tool will work on the 700S pilot jets. I figure I'd better be prepared for what lay ahead now that I'll be rebuilding my carbs and installing larger mains.
While I'm at it, I think I'll start a new carb related thread to ask 2 more questions pertaining to the fuel system.

[Hend238]

I thought I've revive this thread to ask if the Motion Pro tool will work on the 700S pilot jets. I figure I'd better be prepared for what lay ahead now that I'll be rebuilding my carbs and installing larger mains.
While I'm at it, I think I'll start a new carb related thread to ask 2 more questions pertaining to the fuel system.

I've used the motion pro tool on my 750S with success. Same bike as your 700S just the less watered down Canadian version.